Hi Costas
So I assume you have a 3049 E 04 017 in grey livery already converted with a 60987 and you want to add LEDs.
- All LEDs anodes are to be connected with the decoder's blue wire
- the front white LED cathode is to connect to a 2.2 kOhm resistor and the other resistor's side to the decoder's white wire
- the front red LED cathode is to connect to a 2.2 kOhm resistor and the other resistor's side to the decoder's yellow wire
- the rear white LED cathode is to connect to a 2.2 kOhm resistor and the other resistor's side to the decoder's yellow wire
- the rear red LED cathode is to connect to a 2.2 kOhm resistor and the other resistor's side to the decoder's white wire
I hope this helps
Jean

Hi Costas
It is up to you but if you really use a 60987 then orange is a motor connection see here the page of the user's manual. The colors to use are in the green frames of the picture. The common (+) for all outputs is the blue wire


Cheers
Jean

Hi Costas

I have older Layout books but they are with M track. I will be happy to send an electronic copy of what I have but I need your email address you could send me by private message.
I used Wintrack (version 10) and available free 3D buildings (in the swap area of Wintrack website) to figure out the possibilities. I recommend it but it is not the cheapest.
The key things to consider are (IMO):
- all the ramps not to be more than 3% when straight and 2.5% when curved
- build a module approach so you don't have to destroy all if you need to move
- fix yourself a maximum train length and verify that all your train stop zones are above this (I have 2 lengths: full main line train 1.6 m and secondary train .5 m
- critical is to think about the circulations you wish to make to optimize your layout by many simulations
Here is one of the views I obtained using Wintrack

The buildings are not the ones I finally decided for.
Here is the real layout

I hope this helps
Jean

Hi Costas
So to help you I need some info:
- size: L=280cm x W=135cm
- number of levels? 1, 2?
- number of loops 1 or 2?
- number of passing tracks 2 or more?
- number of reversing loops: 0, 1 or 2?
- type of garage tracks: for goods or for long passenger cars?
- number of garage tracks?
- type of track C, K other?
Cheers
Jean

Hi Costas
I haven't received anything
Cheers
Jean

Hi Costas
First I replicated you sketch. Here it is (not grades are OK yet)
Here is the plan

Here is the 3D sketch

Here is from the other side

Not all the grades are correct.

Unlike on your sketch, the tracks take much more space and it is a bit crowded.
I used radii from 360mm and up
I find difficult to add another level on this plan.
What do you think?
Cheers
Jean