 Joined: 26/08/2012(UTC) Posts: 40 Location: California
|
An invitation was made to run European Trains on a NCE DCC system. How do you set an address on a Trix mfx lok to run on aNCE DCC system?
|
 1 user liked this useful post by Imagine
|
|
|
|
Joined: 10/02/2021(UTC) Posts: 3,893 Location: Michigan, Troy
|
Excellent question. This was also asked on a digital club webinar on YouTube. Curtis Jueng and Rick Sinclair basically said that you don't. NCE is a different animal and they didn't elaborate on it. I don't know if it utilizes railcom or not. The way I would try is to program you MFX model on a CS 3 programming track after resetting the decoder and removing it from the roster and only enabling the DCC protocol. Then give it a DCC address.
|
1 user liked this useful post by marklinist5999
|
|
|
|
Joined: 16/02/2004(UTC)
Posts: 15,443
Location: DE-NW
|
Originally Posted by: Imagine  How do you set an address on a Trix mfx lok to run on aNCE DCC system? Use a controller that supports DCC, but not mfx, and set the address as with any other DCC loco. With an MS2, disable mfx and set the address using DCC. Address limit is 10239. With a CS2/CS3, disable mfx and set the address using DCC. Address limit is 9999. |
Regards Tom --- "In all of the gauges, we particularly emphasize a high level of quality, the best possible fidelity to the prototype, and absolute precision. You will see that in all of our products." (from Märklin New Items Brochure 2015, page 1) ROFLBTCUTS  |
2 users liked this useful post by H0
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
