marklin-users.net community | Forum
»
General topics
»
Digital
»
CV for ESU LokSound 4.0 in a bit jerky DCM motor engine
 Joined: 30/08/2002(UTC) Posts: 1,288
|
I have a green Re 4/4 II engine from the older Swiss digital starter set Mä 29859. I have just replaced the original decoder with an ESU LokSound 4.0 decoder. I’m using the motor settings proposed by ESU LokProgrammer. Running features are nice, except the following: When the engine is decelerating and finally stops, it takes an approx. 1 cm jump, and then stops again. I have tried tuning different combos of CV 5x settings, but most often some new negative features show up. Would anyone have a suggestion on which CV:s to adjust?  Edited by user 25 March 2023 01:29:46(UTC)
| Reason: Not specified |
|
|
|
|
|
|
 Joined: 30/01/2006(UTC) Posts: 1,893 Location: Keene, NH
|
I ran into a similar behavior with the Lokpilot/Loksound 4's in my Lima TGV's. Try adjusting CV 52. Try a setting of 35 or 40 and see if that helps.
Mark |
|
 2 users liked this useful post by mmervine
|
|
|
|
Joined: 30/08/2002(UTC) Posts: 1,288
|
Thanks Mark! I ended up reading the ESU manual, increasing the CV 55 for ”Parameter I” a bit made the trick! It’s really running smooth now. Note that the camera picked up a higher sound volume, compared to the experience IRL.  |
|
|
|
|
|
|
Joined: 30/01/2006(UTC) Posts: 1,893 Location: Keene, NH
|
Glad you got it working correctly. I have only had this issue with generation 4 of ESU decoders. |
|
1 user liked this useful post by mmervine
|
|
|
|
marklin-users.net community | Forum
»
General topics
»
Digital
»
CV for ESU LokSound 4.0 in a bit jerky DCM motor engine
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
