Not sure what I have done? None of my power supplies or controllers work? I have place hookups on different pieces of track? Plugged into tow different electrical outlets? Please Marklin Mobile Station track in different spots? Cleaned the tracks? Sometimes the engine will go on the right on the feed of power then stop once off? Could all 3 controllers be done? I haven't used them in a few years? I used the 32 Volt one last a few months ago on dining table it ran almost all my engines? Should I just buy new Central Station? or am I missing something? Suggestions? I attempted to update the Central Station a few years back, it kind of went South then. However the Mobile Station had worked last year?

Hi!

Sometimes attention to details is important. Some locos will not work when red and brown wires of the MS are swapped. Red goes to the B connector and brown goes to the 0 connector of the C track.

The "32 Volt controller" probably is a 16 Volt controller. Some locos must be configured for analogue operation.

Connecting two or more controllers to the same track at the same time can lead to damages, especially of the Mobile Station.

Maybe we can provide better help when you show some pictures of the wiring and provide ref. numbers of the articles you are using.

Ok today new day, took suggestions, just took all track off table, used track that was stored in plastic tubs loose or in Marklin paper boxes. Have two locos thus far circling with Central Station on old track? I don't have all the same radius tracks to put back how it was, or four replacement wide turn switches? However Happy to see loco moving again. Could the track all be bad, it would seem so? I live in Florida, it is hot and humid, I do run A/C all the time? What would make all the pieces of track on table go bad? I even tried to put a piece back into new single ring? Stops loco right it. Bad track? Going to try Mobile Station next.