Welcome to the forum   
Welcome Guest! To enable all features please Login or Register.

Notification

Icon
Error

Share
Options
View
Go to last post in this topic Go to first unread post in this topic
Offline Johnvr  
#1 Posted : 30 November 2019 07:31:18(UTC)
Johnvr

South Africa   
Joined: 03/10/2010(UTC)
Posts: 1,153
Location: Cape Town, South Africa
Hi all,

I have found on a number of occasions that the circumference of the permanent magnet is too tight for the rotor to rotate smoothly.
Hence I have resorted to widening the magnet circumference for the rotor tolerance by using a rotating dremel tool and shaving about 0.5mm off the magnet.

The motor has much smoother running characteristics once the tolerance has been increased and the rotor doesn't touch the magnet.

Has anybody else had the same issue and also widened the gap ?

RegardsBigGrin
John
Offline Gregor  
#2 Posted : 30 November 2019 10:46:19(UTC)
Gregor

Netherlands   
Joined: 17/04/2003(UTC)
Posts: 907
Location: Netherlands
Brave man!

Are you using an old 3-pole DCM anchor in a 6090x permanent magnet? The 5-pole anchors for those magnets have slightly smaller diameter.

Gregor
Users browsing this topic
OceanSpiders 2.0
Forum Jump  
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.

| Powered by YAF.NET | YAF.NET © 2003-2019, Yet Another Forum.NET
This page was generated in 0.208 seconds.