 Joined: 22/08/2018(UTC) Posts: 99 Location: Essex
|
How can you configure RocRail to work with the CS3 plus?
While RocRail indicates that the CS3 is a tested system that works it is not listed in the controller setup screen in RocRail.
Do you just use the Ecos configuration?
John
|
|
|
|
|
|
 Joined: 04/01/2018(UTC) Posts: 33
|
If I remember correctly, there should be an option called mcs2 for the CS2. The CS3 should also work with that, since the protocol to talk to the CS is pretty much the same.
|
|
|
|
|
|
Joined: 22/08/2018(UTC) Posts: 99 Location: Essex
|
Thank you for the information.
Joh
|
|
|
|
|
|
Joined: 22/08/2018(UTC) Posts: 99 Location: Essex
|
Tried the msc2 option in RocRail and it works fine with the CS3.
John
|
|
|
|
|
|
Joined: 21/04/2014(UTC) Posts: 122 Location: ENGLAND
|
2 Years after the last message here and probably a new version of roc rail. I've just tries to add my CS3+ to roc rail and there is no msc2 option in adding a new controller! But In the roc rail online guide https://wiki.rocrail.net/doku.php?id=mbus:cs3-en there is a bit about Note: Only direct TCP communication with the CS2/CS3 is supported in the Rocrail Forum. The protocol I've discovered to add is mbus Then under Rocrail Properties>> Controller Properties>>Interface needs to be set a type> TCP Hostname > (your Cs3 ip address) : 15731 OK then restart roc rail Connected hopefully:-)
|
|
|
|
|
|
 Joined: 21/05/2004(UTC) Posts: 1,768 Location: Brisbane, Queensland
|
Yes it works fine with CS2 as well, been using it ever since the Rocrail change many months ago. |
modelling era IIIa (1951-1955) Germany |
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
