Programming with M.6021

Welcome Guest! To enable all features please Login or Register.

Notification

Error

Programming with M.6021

Options

View

Previous Topic Next Topic

Graham HO		#1 Posted : 18 August 2009 02:02:57(UTC) Retweet
Joined: 03/07/2008(UTC) Posts: 126		Hi - are there any members that have had persoal experience or can advise on programming a Uhl. 76200 lok decoder with M.6021 controller. I need to reduce both the F3 Rangier (switching) speed and maximum speed on a recent conversion. Many thanks in advance.


User Profile View All Posts by User View Thanks


	Wish to join the discussion?! Login to your marklin-users.net community \| Forum account or Register a new forum account. Or Connect via Facebook

efel		#2 Posted : 18 August 2009 02:44:20(UTC) Retweet
Joined: 23/02/2005(UTC) Posts: 800		Hi, Seen on UHL site: Programming with a Märklin Center With a Märklin center all CV's can be programmed, but not read. 1. Switch Center off and on. 2. Select the address of the decoder and switch the light on. 3. Operate the direction change-over 5 times in quick succession with the stationary locomotive (speed step 0), until the light turns off. 4. Set the speed controller to "zero". The rear light now flashes slowly 4 times. 5. Enter the number of the CV that is to be programmed. 6. Briefly operate the direction change-over. The rear light flashes fast 4 times. 7. Enter the desired value for CV e.g. a locomotive address. 8. Briefly operate the direction change-over. The rear light flashes slowly 4 times. If further CV's are to be programmed repeat points 5-8. If programming is to be terminated switch the center to "STOP" or set the address to "80" and briefly operate the direction change-over. Since a Motorola digital center from Märklin only accepts inputs of 01 to 80, the value "0" must be entered by entering the address as "80". NB: "Marklin center" means 6021 Fred


User Profile View All Posts by User View Thanks

H0		#3 Posted : 18 August 2009 02:47:42(UTC) Retweet
Joined: 16/02/2004(UTC) Posts: 15,441 Location: DE-NW		I programmed an Uhlenbrock decoder a few months ago (wasn't a 76200). The loco starts flashing lights when you release the reversing position. That's unlike ESU style decoders where you hold the reversing position until the loco starts flashing. On the 3rd or 4th attempt I managed to change the address. Grrrr - sooner or later all my Uhlenbrock decoders will get a fine place on the book shelf ... Just in case you don't have the manual: look here: http://uhlenbrock.de/GER...64-01B.apd/Bes76200e.pdf
		Regards Tom --- "In all of the gauges, we particularly emphasize a high level of quality, the best possible fidelity to the prototype, and absolute precision. You will see that in all of our products." (from Märklin New Items Brochure 2015, page 1) ROFLBTCUTS


User Profile View All Posts by User View Thanks

Users browsing this topic
Guest

Forum Jump

You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.