Hello Mike,

I bought my 7294 from German eBay four years ago and have just now begun the project of installing it on my layout.

In the interim, like you I was looking for images of the transfer tables in real, mainly to see how the overhead wires are arranged in prototype.

So here are some of the images I collected, I hope they are of some use to you :





























This article from Stummis forum is also of interest : https://www.stummiforum....-rklin-Schiebeb-hne.html (translates well on my computer)

My 7294 came fitted with the double-arch overhead wire supports.
This did not suit me since my layout oberleitung is by Sommerfeldt and I removed the arches (I was not aware of the Sommerfeldt set as shown in the Brima video referred to in the Stummis article above). One notes that the older (prototypical to 7294?, which is said to be of Stuttgart) schiebebühnen have the arches and a single overhead wire on the table bridge (interestingly the second and fourth text images in the stummi article above reveal the four powerline wires running on the edge of the transfer table well which make contact with a receiver on the edge of one arch. They can also be seen in the ninth of the images above).
The more modern transfer tables instead have overhead wires that span each side of the locomotive yard over the transfer table well (seen as early as the era in the thirteenth image above) and the loco once on the table lowers its pantograph, raising it when the table reaches the required siding. This better suited my setup and I am modelling the overheads in the loco yard as seen in this nice video of the locomotive yard and transfer station at the Port of Hamburg :



Regards,

PJ

Zagreb, near the railway vehicle factory Končar

A special measuring vehicle made entirely by us

The train has equipment for recording about 15 different parameters on the infrastructure, and is equipped with a kitchenette, a toilet, a shower cabin and a bedroom with 2 beds.