Welcome to the forum   
Welcome Guest! To enable all features please Login or Register.



Go to last post in this topic Go to first unread post in this topic
Offline Richard556  
#1 Posted : 23 October 2021 12:05:46(UTC)

New Zealand   
Joined: 20/11/2010(UTC)
Posts: 27
Location: New Zealand

I've been playing around with some Marklin 59083/59084 1 gauge points (600mm long, 10 degree, ex-hubner turnouts).

They come with a switch stand, point motor, decoder, and polarised frog, and once you assemble they work pretty well. However the linkage between the point motor and the switch blades lever is a single metal pin which is dropped in from the top and is not secured - and if you tip the points upside down (for example once it is installed on a module which is placed in storage) I can see the pin just falling out and getting lost.

Has anyone had experience with these points? What do you do to secure the pin? The instructions are pretty minimalist...

Users browsing this topic
OceanSpiders 2.0
Forum Jump  
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.

| Powered by YAF.NET | YAF.NET © 2003-2021, Yet Another Forum.NET
This page was generated in 0.300 seconds.