mfx m84 and tortoise motor

Welcome Guest! To enable all features please Login or Register.

Notification

Error

mfx m84 and tortoise motor

Options

View

Previous Topic Next Topic

Goofy		#1 Posted : 21 September 2018 17:12:28(UTC) Retweet
Joined: 12/08/2006(UTC) Posts: 9,290		Did just tested turnout motor with the m84. It works nice! I did used extern trafo 16 Vac to feed the turnout motor with two diodes to connect half-wave voltage. The power was digital direct to the m84 and don´t need extern feeder.
		H0 DCC = Digital Command Control

7 users liked this useful post by Goofy		Crazy Harry, Minok, Danlake, boitpo, xxup, siroljuk, dickinsonj
User Profile View All Posts by User View Thanks


	Wish to join the discussion?! Login to your marklin-users.net community \| Forum account or Register a new forum account. Or Connect via Facebook

David Dewar		#2 Posted : 21 September 2018 23:51:44(UTC) Retweet
Joined: 01/02/2004(UTC) Posts: 7,464 Location: Scotland		Well done Goofy. Good to see you are enjoying your CS3.
		Take care I like Marklin and will defend the worlds greatest model rail manufacturer.


User Profile View All Posts by User View Thanks

Goofy		#3 Posted : 22 September 2018 08:44:05(UTC) Retweet
Joined: 12/08/2006(UTC) Posts: 9,290		Originally Posted by: David Dewar Well done Goofy. Good to see you are enjoying your CS3. Thank you! I shall do some project by test two switchable contact on the tortoise motor via reed contact from the m84.
		H0 DCC = Digital Command Control

1 user liked this useful post by Goofy		Crazy Harry
User Profile View All Posts by User View Thanks

Users browsing this topic
Guest

Forum Jump

You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.