Welcome to the forum   
Welcome Guest! To enable all features please Login or Register.

Notification

Icon
Error

Share
Options
View
Go to last post in this topic Go to first unread post in this topic
Offline Goofy  
#1 Posted : 21 September 2018 17:12:28(UTC)
Goofy


Joined: 12/08/2006(UTC)
Posts: 8,993
Did just tested turnout motor with the m84.
It works nice!
I did used extern trafo 16 Vac to feed the turnout motor with two diodes to connect half-wave voltage.
The power was digital direct to the m84 and don´t need extern feeder.

DSC_0001_619.JPGDSC_0002_620.JPGDSC_0003_621.JPGDSC_0004_622.JPG
H0
DCC = Digital Command Control
thanks 7 users liked this useful post by Goofy
Online David Dewar  
#2 Posted : 21 September 2018 23:51:44(UTC)
David Dewar

Scotland   
Joined: 01/02/2004(UTC)
Posts: 7,333
Location: Scotland
Well done Goofy. Good to see you are enjoying your CS3.
Take care I like Marklin and will defend the worlds greatest model rail manufacturer.
Offline Goofy  
#3 Posted : 22 September 2018 08:44:05(UTC)
Goofy


Joined: 12/08/2006(UTC)
Posts: 8,993
Originally Posted by: David Dewar Go to Quoted Post
Well done Goofy. Good to see you are enjoying your CS3.


Thank you!
I shall do some project by test two switchable contact on the tortoise motor via reed contact from the m84.

H0
DCC = Digital Command Control
thanks 1 user liked this useful post by Goofy
Users browsing this topic
Forum Jump  
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.

| Powered by YAF.NET | YAF.NET © 2003-2024, Yet Another Forum.NET
This page was generated in 0.326 seconds.