Hello Everyone

Last weekend I received a damaged Marklin 89941 Transfer Table (I believe it was a bargain in a flea market).

It has some damage, that I can repair, but no control unit.

The question I have is:

Does this control unit, have a "timer" that shuts down energy when the sliding track needs to stop on the next position? Or is it just an impulse that sends the sliding track until it stops in the next position?

If it is the latter one, I can easily use a 6 Pin DPDT Momentary Switch On-Off-On Motor Reverse Polarity DC like the one bellow. Can anyone shed some light in this subject???



Thank You all

Best Regards
Ricardo