Hi All

I have just received my new CS3 . I ported the data, as per the instructions from my CS2 in particular the
Track diagram. When I looked at the track Diagram on the CS3, it reminded me of a plate of saghetti - a right mess.

So I started to enter it a new. I have a situation where I have 3 uncouplers with the same address, yet on the Track diagram editor it only will allow one uncoupler to be placed on the diagram for a particular address. Does anybody have a solution for this ?

I am also in need of documentation of how to transfer/install my turntable on the CS3 track diagram,

Thanks in advance.

Tim