Hello

I have the model 37265 and want's to upgrade it to MFX with a LokPilot or LokSound decoder...

I have already got the 21-pol PCB from the model 37266.
As this model's have a small special motor, i.e. not DCM motor, I need the motor CV's...

The following are of interest:
Anfahrspannung : 0 - 255 = ?
Maximalgeschwindigheit : 0 - 255 = ?
Regelungsreferenz : 0 - 255 = ?
Regelungsparameter I : 0 - 255 = ?
Regelungsparameter K : 0 - 255 = ?
Regelungs Einfluss : 0 - 255 = ?

Thank's

On page 35 of the English version of the ESU LokPilot V3.0 manual are recommended CV settings for various motors.
I think this is what you are asking for.
Eric

That's what I was hoping for

I gave the railcar to one of our members to fine tune. He is also going to get the parameters you requested.

Here is the email from Dennis:

Hi Tony,

I cracked open your 37266 just now. Haven't had a chance to look at the problem yet, but the decoder parameters read as follows:

Anfahrspannung : 0 - 255 = 5
Maximalgeschwindigheit : 0 - 255 = 254
Regelungsreferenz : 0 - 255 = 100
Regelungsparameter I : 0 - 255 = 70
Regelungsparameter K : 0 - 255 = 120
Regelungs Einfluss : 0 - 255 = 255

also:
Acceleration (CV3) = 20
Deceleration (CV4) = 17

The decoder fitted is a standard ESU MFX Lopi, and I've attached the esu lokprogrammer file to this mail. If your man has got a lokprogrammer he can just upload that file and it'll set the whole thing up for him. If he hasn't then he'll need to key in the above parameters by hand.