Excuse my ignorance here..

I have two locos that really do not respond well to the intellibox, on being a conversion [Roco] and the other a Br 39 Rivarossi.

Both work a dream on a repair track using my old 6021.

Hwver if I use them on the main track and a short ar stall then its reset and sometimnes a while before I get a response.I amso have a Delta 03 that works miles better on the old trafo..

So is it possible to work these two systems in tandem..

To clarify what Thomas said, you can get an adapter plug for the IB that will allow you to connect a 6021 to the IB and use it as a third controller.

Thanks.

Whats does this connector look like ?

I had rigged the 6021 up with a separate transformer and feed...that did not work. Need a booster too...

Is it known that some lOcos prefer the old controller...

Part number of the adaptor should be 61020 and looks like this.

Hello, Ralph,

when you get the adapter from Uhlenbrock you can connect the 6021 via M* cable 6038 (180 cm) or 6039 (60 cm).
The maximum bus length is 6 metres.

Here you'll find two in Germany:
http://www.google.de/products?q=uhlenbrock+61020

I already ordered from SC99 - they send the invoice immediately and request the money, even if items are not yet on stock (all other dealers I know send the invoice when the items are on stock).
But so far I always got what I paid for.

You'll probably find some dealers not listed with froogle.

Thank you for that most kind offer.

Quite a community this.....

Now I am intrigued having set up some track to test the troublesome two or 3 locos on 6021 and then Intellibox.

A delta Br03 which despite armature cleaning light oil new brushes etc struggles at low speeds and stalls in reverse, works loads better.

More puzzling [and its only 3 out of 50 locos, is why two will intermittently work on Intellibox and if there a sort or stall sometimes take ages or a 're boot' to go.

On the 6021 both work flawlessly.

Do I need a booster, its now quite and extensive line, double tract loop of sorts over 7/8 meters loop, regular feeds on K track but some of the connectors may need a look.

But been using test track I get this difference.

Now if the 6021 will sit alongside the INtellibox via the lead then I suppose job's a good 'un...<font face="Arial]</font id="Arial]<font face="Times New Roman]</font id="Times New Roman]

Thanks I will check...

narrowed it down to 2 now as my 03 it turns out after careful watching has damned awkward problem [it was second hand] the main bolt holding the valve gear in place is stripped so the Walschearts crank slips out of position and locks.

New wheel ..I'll have to send her away to be fixed and get rid of the Delta decoder at the same time..

That works fine, a control point can now be set up the other side of the room.

Some older delta locos seem to run better on it.

Now to the oddities, a Rivarossi loco Br 39 , wont move on Intellibox.Segregate the 6021 to a test track, run the engine, then re start the Intellibox and Ok we go...

Weird...

Thanks you !