SOLVED

So easy!!!! I found that the power supply definet in the setup was not the one I was using! Just changed it to 60052 that is the one I have for power supply to the CS2 and error dissapeared!

I keep anyway this post for the case it can be useful for any other one with similar silly problem.

*****************

Hi, I have a 60213 CS2 Hw version 3.1

It used to work OK with SW version 4.1.2, today I updated it to 4.3.0(34) and since then, without any external connection (except the transformer 60052), once it starts, message:

"An overload situation occurred on channel VOLT on device Central Station 2 #1748. Eliminate the cause or check the power supply settings!"

I changed the transformer and same situation arises.

For the case it is a problem of the update 4.3.0, Is there any way I can go back to the 4.1.2? I already tried to install 4.2.0 that I had in an USB, but the SW version stays as 4.3

Thanks for any help.

Javier