 Joined: 25/02/2023(UTC) Posts: 1 Location: Sapanca, Sakarya
|
Hi everybody. I'm using a Marklin CS3+ on my layout.
I noticed that, in settings page of the device, it always shows a current draw on programming track, 0.009 amps or 0.010 amps.
I stop the device, disconnect programming track wire from the back, it still shows this current draw. Is it normal?
Anyone experiencing this issue? There is nothing wrong with the operation by the way.
Best regards to all.
Derin
|
|
|
|
|
|
 Joined: 04/02/2011(UTC) Posts: 3,555 Location: Paris, France
|
Hi Derin
On my present CS3 the current is zero when there is nothing on the track. It remains zero when a recent MFX loco is placed on the track with all functions off except lights
On my previous CS2s (Two 60215), one of them would indicate a tiny current when no load was connected.
This shows, I think, that the current measure is not a Swiss precision mostly at low values.
So I wouldn't bother so much.
Cheers
Jean |
|
 2 users liked this useful post by JohnjeanB
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
