marklin-users.net community | Forum
»
General topics
»
Digital
»
Please choose motor conversion for TEE marklin#3071
Joined: 20/12/2011(UTC)
Posts: 31
|
Dear my friend.
I just boughh it in last week ang need to run it in my layout with mobile station1.
Please help me to choose moter conversion set & decorder.
60944?+ 60760?
Anyway, lamp will be changed to LED .
Regards,
ThanethM
|
|
|
|
|
|
 Joined: 14/03/2005(UTC) Posts: 15,870 Location: Gibraltar, Europe
|
Hi,
I converted mine with a 60944 motor kit and a 60942 MLD decoder. You can probably use the decoder from the 60760 kit, but I chose the MLD to give me MFX auto-registration. It's also a better decoder performance-wise.
I kept the original bulbs, and re-used the wiring that runs through the train for the white and red lamps at each end. However I had to do without the ability to change sliders from one end to the other, so as to simplify the conversion. |
Ray
Mostly Marklin.Selection of different eras and European railways
Small C track layout, control by MS2, 100+ trains but run 4-5 at a time.
|
|
|
|
|
|
 Joined: 16/08/2006(UTC) Posts: 5,382 Location: Akershus, Norway
|
I did a full rebuild, with additional wires through the train, and relays to control the interior light and rear lights.
In addition a bi-stable relay to switch between the two pick-up shoes.
This was doen a long time ago, with the conversion set 60904. Today that means motor set 60944 and decoder 60942, as stated by Ray.
If I should do this today (and maybe a future improvement) I would use an mfx sound decoder, as I did in the set 37500.
For further detail, see my website. |
Best regards Svein, Norway
grumpy old sod
|
|
|
|
|
|
Joined: 20/12/2011(UTC)
Posts: 31
|
I will order motor conversion set-decorder form Germany as soon.
Thank a lot
|
|
|
|
|
|
Joined: 20/12/2011(UTC)
Posts: 31
|
Dear Sir. Yesterday, i trial to use deltra decorder 66031 to run this car with orginal lamp as temporary After connect yellow,gray wire to front-rear lamp that are conected to locomotive frame. When .No running as stop locomotive lamps : OK can be operated But after running locomotive I found that yellow,gray function are broken / zero volt==>fail But other functions as motor ,aux were still OK Please recommend me Thank thanethm11 attached the following image(s):
|
|
|
|
|
|
marklin-users.net community | Forum
»
General topics
»
Digital
»
Please choose motor conversion for TEE marklin#3071
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
