 Joined: 26/07/2021(UTC) Posts: 635 Location: Sydney
|
Needed a bit on extra snow on the lower slopes. The Mistral will come through tomorrow and melt all the snow! About half a day's work, The guard on the back of the fan was a repurposed 1:200 stainless steel etched outdoor table cut into a rough circle. Painted the parts separately, a lot easier than masking. The outside diameter is 6.3mm so about 20% over size, that was the size styrene tube that worked best, then the next size down for the inner sleeve. The snow gun is so small in Z gauge it's probably a bit better a bit over size that one can actually see it.      Edited by user 01 January 2022 02:32:39(UTC)
| Reason: Added photo with ruler in foreground for reference.
|
 9 users liked this useful post by Toosmall
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
