marklin-users.net community | Forum
»
General topics
»
General MRR
»
three way turnout c - track lantern to be installed
 Joined: 10/11/2008(UTC) Posts: 120 Location: Far Hills NJ
|
Questions:
So i have been installing Marklin 74470 C - track lanterns, then I came to the Marklin three way 24630 installed the lanterns, but no where to do the wiring or the led strip, any suggestions
|
|
|
|
|
|
 Joined: 04/02/2011(UTC) Posts: 3,563 Location: Paris, France
|
Hi
Not sure I understand your question
One way to connect Lantern LEDs is to solder them to the O and B connections
The other way is to have a separate power for those LEDs the current is so small it does make any difference
Cheers
Jean |
|
|
|
|
|
|
 Joined: 04/04/2013(UTC) Posts: 1,291 Location: Port Moody, BC
|
If you follow the lantern instruction diagram you will see that the LED strips are mounted directly in 2 places without using the usual left and right hand plastic strip holders. The yellow and brown wires are connected to your external lighting bus system as usual, or if you are using digital power directly from the turnout, they can be soldered to the B and O spades as suggested by JohnjeanB. However, if you have a lot of turnouts, I would suggest that you wire them to a dedicated lighting bus.
Peter
|
|
|
|
|
|
marklin-users.net community | Forum
»
General topics
»
General MRR
»
three way turnout c - track lantern to be installed
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
