Hello, this is a request to fix a couple of configuration points in mapping the mix card for the Märklin 38201 loco.
I was Mapping, when the electric supply at home went down. It lasted over two hours. I had several mess ups, but fixed them. However, two are still outstanding. First, my engine noise seems to have been lost the “braking sound” and secondly the “Drvers cab light is blank.
I have asked Märklin customer service, no reply, several YouTube channels without any look.
What I need is a kind person that owns this loco and users the CS3, to photograph the screen images for these mapping configurations.
There are so many computations that it is really frustrating trying all the different sequences.
If anyone can help my, I would be so very grateful. Tony

Hello and thanks for the reply. I haven’t tried the reset, because I have been afraid of loosing all the sounds etc., as you do with ESU Locksound.
Because, the response from Märklin has been zero, I am concerned if it clears all the data, I will have to return it to Germany. As late this has been a nightmare as customs charge me each time.
Thank you again, best regards Tony

Hello Nigel
Thanks for the offer, but I live in Norfolk, near Cromer. It’s a bit far for you and not an easy journey.
I do welcome the offer, but I think it is unfair on you.
I know how to enter the data, it’s just the loads of permutations that there are, that why I am looking for photos of the CS3 screens.
Thanks again Nigel

You could do a factory reset which should restore the decoder to all the factory settings. But I would first try to locate which CVs control the two functions you want to activate and confirm that they are turned on. Also, since the braking squeal is tied to the braking delay and the speed of the loco when stopped or slowed I would also confirm that the braking delay function is set properly. Try both extremes 0-255.

Hello
You can download the project at marklin site and open it with the mdecodertool3 and check all the values you need.
Regards