 Joined: 05/07/2020(UTC) Posts: 326 Location: Mississippi, Vancleave
|
After I have my M track sections and turnouts screwed down to the board, if I want to replace a section or turnout, I find it difficult to do without removing just about all the screws. Have you found an acceptable way to replace a track section without removing all the screws?
|
|
|
|
|
|
Joined: 16/02/2004(UTC)
Posts: 15,443
Location: DE-NW
|
Originally Posted by: Mr. Ron  Have you found an acceptable way to replace a track section without removing all the screws? Stating the obvious: You don't have to put two screws into each track. You don't have to put screws into every track. But in the end you still have to remove a few screws to remove a piece of track. Having a segmented layout could make things easier. Of course, with screws used sparingly some tracks can be moved a bit. This can be a problem with decoration on the layout. Things become much more complicated when you start to ballast the tracks on the layout. Make excessive tests before ballasting. Make turnout motors accessible from below. |
Regards Tom --- "In all of the gauges, we particularly emphasize a high level of quality, the best possible fidelity to the prototype, and absolute precision. You will see that in all of our products." (from Märklin New Items Brochure 2015, page 1) ROFLBTCUTS  |
 2 users liked this useful post by H0
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
