 Joined: 22/01/2012(UTC) Posts: 1,047
|
Hi, I have this Belgian diesel box says 3459 and has the delta sticker on it, instruction manual is for 3464/3664. It is set for address 72, At the moment all delta decoders I remember had the dip switches like in the instructions but this one doesn't. I have not been able to change the address to one of the few delta much less to any full digital address. That is with my Ecos. Is this a regular delta decoder? Any comments, suggestions? Iamnotthecrazyone attached the following image(s):
|
|
|
|
|
|
 Joined: 19/12/2011(UTC) Posts: 112 Location: Madrid Spain
|
Some Delta decoders have no dip switches. This is one of them.
Kind regards
|
 1 user liked this useful post by RUBEN SPAIN
|
|
|
|
 Joined: 14/01/2006(UTC) Posts: 1,802 Location: Wurttemberg
|
Hi,
this is a very early and rare DELTA-decoder offered 1992/1993. Unlike later versions it recognises the operation mode (analogue/digital) and has no dip switches. The adress can be changed by soldering on the bridges on the upper right corner (your photo) of the decoder.
Regards
Markus
|
1 user liked this useful post by Markus Schild
|
|
|
|
 Joined: 18/11/2007(UTC) Posts: 113
|
The Decoder shown on the Picture is a Marklin 6603 Decoder, version 1 without dipswitches , later the 6603, Version 2 came with 4 Dipswitches. I Have attached a PDF-file to this post, which will show you how to solder the bridges to set the adress you want for the locomotive. Hope this will help you Frank. F |
CS3+ 60216 ( SW:2.5.2 ) / CS2 60215 ( SW:4.3.0 ) / MS2 60653/57 ( SW:4.28 ) / MS1 60652 ( SW:1.8 AP ) / 60883 S88 LINK ( SW:1.1 )
MDT 3 (SW 3.6.0) - HW: ( 60970 / 60971 / 60801 ) & ESU LOKPROGRAMMER ( SW 5.2.12 ) / ESU HW: 53451 / 53900 / 53901
|
1 user liked this useful post by FrankF
|
|
|
|
Joined: 22/01/2012(UTC) Posts: 1,047
|
Originally Posted by: FrankF  The Decoder shown on the Picture is a Marklin 6603 Decoder, version 1 without dipswitches , later the 6603, Version 2 came with 4 Dipswitches.
I Have attached a PDF-file to this post, which will show you how to solder the bridges to set the adress you want for the locomotive.
Hope this will help you
Frank. F Not a problem but not a very user friendly for someone without tools or knowledge. The pdf is very useful I have printed it and I'll put it in the box so next time I'll pull that loco Idon't start this all over again  Thank you, Alex.
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
