marklin-users.net community | Forum

 
Welcome to the forum   
Welcome Guest! To enable all features please Login or Register.

Notification

Icon
Error
Decoder reset question
Share
Options
View
Go to last post in this topic Go to first unread post in this topic
Previous Topic Next Topic
Offline Gregzim  
#1 Posted : 06 August 2016 10:34:55(UTC)
Retweet
Gregzim

Australia   
Joined: 09/11/2007(UTC)
Posts: 116
Location: Melbourne, Australia
Hi. I entered '08' into CV8 on a loksound V4 decoder on Ecos and it says "OK".

THe loco however now has no response. I re read CV8 and its now reads address "151" whihc I ressed check on - but no difference so I assume there are now other steps to do?

All help appreciated thanks.

Rgds

Greg
Back to top

Wish to join the discussion?! Login to your marklin-users.net community | Forum accountor Register a new forum account. Or Connect via Facebook  
Back to top  
Offline RayF  
#2 Posted : 06 August 2016 16:43:24(UTC)
Retweet
RayF

Gibraltar   
Joined: 14/03/2005(UTC)
Posts: 15,839
Location: Gibraltar, Europe
Hi Greg,

The default address for Lokpilots is "03" I believe. Have you tried entering that address for the loco?
Ray
Mostly Marklin.Selection of different eras and European railways
Small C track layout, control by MS2, 100+ trains but run 4-5 at a time.
Back to top
Offline river6109  
#3 Posted : 14 August 2016 10:31:31(UTC)
Retweet
river6109

Australia   
Joined: 22/01/2009(UTC)
Posts: 14,726
Location: On 1965 Märklin Boulevard just around from Roco Square
Greg, CV 8 is resetting the decoder but you have to put in Value 8 as well , that is if you have a lokprogrammer. also if RailComPlus is activated you may have to re-register the loco on your test track.

John
https://www.youtube.com/river6109
https://www.youtube.com/6109river
5 years in Destruction mode
50 years in Repairing mode
Back to top
WWW
Offline Goofy  
#4 Posted : 14 August 2016 10:33:36(UTC)
Retweet
Goofy


Joined: 12/08/2006(UTC)
Posts: 9,019
If yours loco adress are 3,put the loco on the programming track and go to the CV adress 8.
Write value 8 and confirm it by press enter.
H0
DCC = Digital Command Control
Back to top
Users browsing this topic
Guest
Forum Jump  
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.

| Powered by YAF.NET | YAF.NET © 2003-2024, Yet Another Forum.NET
This page was generated in 0.417 seconds.